🔹 Components

  • 1 Breadboard (half size)
  • 10 LEDs (mix of red, green, blue, yellow)
  • 1 RGB LED
  • 1 Buzzer (active)
  • 2 Push Buttons
  • 5 × 220Ω resistors, 3 × 10kΩ resistors
  • 10 Jumper Wires (M–M)
  • 1 LDR Sensor
  • 1 IR Obstacle Sensor
  • 1 Mini Screwdriver + QR project booklet

🔹 Projects You Can Build with This Kit

No.Project NameComponents UsedWorking Principle / Description
1LED ON–OFF Using Push Button1 LED, 1 Push Button, 1×220Ω Resistor, Jumper WiresPress the button to complete the circuit and turn ON the LED. Release to turn it OFF. Demonstrates simple switching.
2Dual Button LED Control2 LEDs, 2 Push Buttons, 2×220Ω ResistorsEach button independently controls its own LED — parallel control circuit.
3LED AND Logic Gate1 LED, 2 Push Buttons, 1×220Ω ResistorLED glows only when both buttons are pressed together — simulates AND gate logic.
4LED OR Logic Gate1 LED, 2 Push Buttons, 1×220Ω ResistorLED glows when either button is pressed — simulates OR gate logic.
5LDR Light Sensor LED (Automatic Night Lamp)1 LED, 1 LDR, 1×10kΩ Resistor, 1×220Ω ResistorLED turns ON in dark and OFF in light using an LDR voltage divider circuit.
6IR Obstacle Detector LED/BuzzerIR Sensor, 1 LED or Buzzer, 1×220Ω ResistorIR sensor output goes LOW/HIGH when object detected — LED or buzzer indicates obstacle.


No.Project NameComponents UsedWorking Principle / Description
7RGB LED Manual Color Mixer1 RGB LED, 3 Push Buttons, 3×220Ω ResistorsEach button controls Red, Green, or Blue pin. Mixing buttons changes LED color.
8Button-Controlled Buzzer1 Buzzer, 1 Push ButtonPress button to activate the buzzer — demonstrates simple output control.
9Light-Controlled Buzzer Alarm1 Buzzer, 1 LDR, 1×10kΩ ResistorBuzzer turns ON in dark (or vice versa) — works as light/dark alarm.
10Obstacle Detection AlarmIR Sensor, 1 BuzzerBuzzer beeps when object is near IR sensor — acts as mini security alarm.